KOREVER-LITE SS150TYPE 1
      EMULSION FOR INTERIOR (COMMON CORRIDOR)

GENERIC DESCRIPTION
KOREVER-LITE SS150T1 is an acrylic copolymer emulsion, which is developed for use on all interior masonry surfaces of buildings under the humid tropics. It is recommended especially for areas where the surfaces are expose to weathering condition, which often causes discoloration and chalking. It has excellent anti-fungus and weather resistance properties.

RECOMMENDED USES
As a finishing coat for plastered walls & ceilings, cement, concrete, brick, stucco, asbestos-cement sheets and hard/ soft boards, etc....

FEATURES
Good resistance to fungal attack
Good hiding power
Good adhesive strength
Good colour retention and durability
Good alkaline resistance

TECHNICAL SPECIFICATION

Colour Refer to KCC standard colour card
Finish Slight sheen
Solids By Volume 36% depending on colour
Theoretical Coverage 12m2/L at 30 microns DFT
Dry Film Thickness 30 - 35 microns per coat
Drying Time ( 27 deg. C, 80% RH) Surface Dry: 30minutes    Hard Dry: 1 hour
Re-Coating Interval 1 hour
Thinning Clean fresh water
Thinning Ratio Ready for use, approx 0%~10% of thinning if desired

METHOD OF APPLICATION
Brush Roller or Spray.

SURFACE PREPARATION
Surface must be thoroughly clean, dry and free of all loose dirt, chalk or grease.
On previously painted surface, wash using a high-pressure water jet.
On surface previously affected by algae and fungi, apply a fungicidal wash treatment.
Unstable or powdery surface should be removed.
Do not apply in wet weather conditions or when water content in substrate is above 6%.
Do not apply coat for exterior wall surface, which is in direct contact with the weather.